LED Lightbulbs
I've just tried it a couple of times and it's booted normally. It must have been a coincidence. A quick google came up with thisadam2 wrote:Have you repeated the experiment to see if the intference was real, or a coincidence ?
http://www.lowemfoffice.com/led_light_bulbs_emf.htm
which was a bit worrisome so I thought I'd check here.
Both the netbook and the bulb are CE marked.
The most likely problem would be disturbance on the mains rather than emitted radiation so from a personal perspective no issue. It may not be continuous though possibly just related to supply stability.
Adam is (as normal) correct if both carry the CE mark there should be no issue on mains or RFI BUT I've seen on some low cost LED drivers we examined definite evidence that especially when turned on they create mains noise.
In some case we find some of the lower cost luminaires on the market are provided with drivers (power supplies) with insufficient protection from normal noise levels (small transients make them unstable) in others the driver creates problems or generates a supply which is really not suitable for use with an LED light source. In one case part rectified with no smoothing, not a great light source to try to read with.
For information in the mainstream profession luminaires market we are now at over 4000 lumen nominal on system (product) level. Above 5000 lumen at source level. From someone who was slightly skeptical about LED a few years ago I find myself working in a factory where it has become more than 50% of our business in one year. This year we shipped something around 200k pieces of LED luminaires, the largest part of which went into supermarkets for shop lighting.
Adam is (as normal) correct if both carry the CE mark there should be no issue on mains or RFI BUT I've seen on some low cost LED drivers we examined definite evidence that especially when turned on they create mains noise.
In some case we find some of the lower cost luminaires on the market are provided with drivers (power supplies) with insufficient protection from normal noise levels (small transients make them unstable) in others the driver creates problems or generates a supply which is really not suitable for use with an LED light source. In one case part rectified with no smoothing, not a great light source to try to read with.
For information in the mainstream profession luminaires market we are now at over 4000 lumen nominal on system (product) level. Above 5000 lumen at source level. From someone who was slightly skeptical about LED a few years ago I find myself working in a factory where it has become more than 50% of our business in one year. This year we shipped something around 200k pieces of LED luminaires, the largest part of which went into supermarkets for shop lighting.
I seem to get a lot of mains noise switching on lights and other things, makes the radio splutter. The bulb had already been on for a few minutes before the netbook failed to boot, presumably any noise would have died down by then?revdode wrote:The most likely problem would be disturbance on the mains rather than emitted radiation so from a personal perspective no issue. It may not be continuous though possibly just related to supply stability.
Adam is (as normal) correct if both carry the CE mark there should be no issue on mains or RFI BUT I've seen on some low cost LED drivers we examined definite evidence that especially when turned on they create mains noise.
Tried using a battery powered radio around the lamp and there was no interference at all so that's OK.
Envirolink NW have produced a guide to LED Lighting:
http://www.envirolinknorthwest.co.uk/En ... ghting.pdf
http://www.envirolinknorthwest.co.uk/En ... ghting.pdf
- lancasterlad
- Posts: 359
- Joined: 22 Jun 2007, 06:29
- Location: North Lancashire
-
- Posts: 447
- Joined: 23 Aug 2008, 21:49
- Location: Adrift in the UK