Solar Power and Combi boiler

Is Solar Power going to give the UK the energy it needs for the 21st century?

Moderator: Peak Moderation

Posts: 2451
Joined: Tue Nov 29, 2011 10:32 pm
Location: Ross-shire, Scotland

Post by Tarrel »

vtsnowedin wrote:
Tarrel wrote:Nothing wrong with the zig zag line. Water under mains pressure would normally feed into the combi-boiler and be heated instantaneously as it flows through to the taps. The system as shown is merely pre-heating the water before it enters the combi-boiler so the boiler has less work to do, if any.
Yes there is nothing "wrong" with the zig zag line it is just how they depict a coil inside a tank that's contents are isolated from mixing with the contents of the tank and can be at a separate pressure. I merely pointed it out as the written description of the system did not agree with the drawing.
Even if your solar collectors could work at your mains pressure you might want to maintain the separation as it would guard against a leak in your system leading to a major loss of metered/billed mains water. Here in Vermont solar thermal panels usually have non toxic antifreeze in them and that of course needs to be kept isolated from your consumable water supply.
Yes, I think the confusion has arisen because the normal Solartwin system that Emord has will not need the coil (unless they too are heating mains-pressure water). As I understand it, the Solartwin system was designed from the ground up with simplicity in mind. No need for antifreeze, hence no need for separation of the solar water and the rest of the water, hence lower cost and less complication. The solar PV-powered pump is a nice touch. The stronger the sun, the faster the pump runs, and therefore the faster the flow rate through the collectors.

IIRC, the Solartwin is a British system. Not sure if its antifreeze-free design would stand up to the lower temps typical of a New England winter?
Engage in geo-engineering. Plant a tree today.
kenneal - lagger
Site Admin
Posts: 12401
Joined: Wed Sep 20, 2006 2:35 am
Location: Newbury, Berkshire

Post by kenneal - lagger »

Em is correct on a normal Solartwin system but we had a similar system to the one shown in that we had mains pressure hot water.

Vt is correct on the system shown. Not only has the system shown got a closed mains pressure hot water supply coil but it is stated to be a vented tank. If this had a mains pressure feed it would just blow water out of the tank all the time.
Action is the antidote to despair - Joan Baez
User avatar
Posts: 14625
Joined: Wed Sep 05, 2007 4:36 pm
Location: Hou�sʇlʎ' ᴉʇ,s ɹ��llʎ uoʇ �oɹʇɥ ʇɥ� �ɟɟoɹʇ' pou,ʇ �ʌ�u qoʇɥ�ɹ˙

Post by emordnilap »

Tarrel wrote:IIRC, the Solartwin is a British system. Not sure if its antifreeze-free design would stand up to the lower temps typical of a New England winter?
From Solartwin's website (I realise this doesn't actually address your question but it was just a quick search):
Solartwin’s freeze-tolerant, corrosion-resistant solar pipes are made of silicone rubber. Its extreme temperature tolerance range is: -60C to +200C
I experience pleasure and pains, and pursue goals in service of them, so I cannot reasonably deny the right of other sentient agents to do the same - Steven Pinker
Post Reply